Plant Tying Tape Too
Plant Tying Tape Too
Maintenance Method:
- If the tying hand machine of the blade is not able to cut the belt, please use a long flat nose plier to pull out the used blade, and change a new one.
- When the staple in the hand tying machine is blocked, you can use nipper or small screwdriver to get it out. (If 1 long section staple break into 2 section, we also can use one by one section to avoid be blocked.)
- Add lubricant oil to every joint if tool binder machine are long time using.
Steps of Operation:
- Hold handle and press down with force, when you hear a voice of "da", press little bit further you will hear a voice ”da” again, the tape is attached by hook, loose handle to take out the tape, pay attention that you can't use an excessive force.
- The branch of plant need to bind overlap from support / line and other materials, and tie both them with the tape, and quickly press down the handle by force.
- After cut the adhesive tape off you should loosen the handle quickly and make redundant small tape to spring out.
- Attention: Tape bound should be parallel with nail groove.
Material: Made up of stainless steel. Provides a secure tie, ensuring security for valuable vines and trees.
Easy to Use: First you may pull out the strap then put the branch into the strap,press down and release the binding machine.Package your plants effectively.
Time saver – This tying stapler makes trellising your plants much more efficient than using zip ties and cable ties.
Packing Details:The plant tying tool comes with 6 rolls of tapes and a box of staples, ensuring security for valuable vines and trees
Widely Usage:Our tape tool can be used for different kinds of plants such as grapes, tomatoes, cucumbers, peppers, flowers and the branches of plant
How to load the staples?
|
|
|
---|---|---|
Remove the staple pusher unit located near the grip. |
Load the staples in with the prongs facing up. |
Reinsert the staple pusher unit and snap securely back intoplace. |
How to install tape?
|
|
|
---|---|---|
Open the tape holder and ribbon holding area cover. |
Place the tape and feed the ribbon along the ribbon holding area. |
Feed the tape through the slotted opening at the front of thestapler. |
|
|
|
---|